[admin]

I am building a small hand held pump. I need help finding a bulb based hand pump and a pressure relief valve(low pressure and low volume).

[admin]

im rebuilding my middle weight battlebot and im putting in a new pneumatics system. I am going to put two valves into one actuator for more speed. How can i find out the speed of the actuator. Anyone know were i could buy cheap norgren stuff.fea

[admin]

First off, SCFM is the flow of standard cubic foot of free air per minute. This assumes there are no restrictions in the line which could cause pressure drop. An example is a piece of straight pipe. Cv on the other hand takes into account press

[admin]

Can someone tell me why FRL's are generally measured in SCFM? Why not Cv? Hope this question isn't too general (or dumb)Thanks

[admin]

we are and Italian company making Miniature Solenoid Valves-10mm and 15mm.We suggest you to visit our site at:www.fimvalvole.com or to contact us for any information or for our catalogue. Fim ValvoleVle Europa -26855-Lodi Vecchio- ItalyTel(39) 037

[admin]

We're hooking up solenoids to a low-pressure air supply–1-4psi. The 10 bellow units receiving pressure each have a volume of approx 1 liter and will achieve up to 0.3psi. We want to inflate and deflate the bellows quickly. We want to be able to

[admin]

Would like some info. on air amplifiers. Require 80 psi max. input. 90 psi is required output. 14 SCFM. Any info. would be appreciated. I am aware of Haskel and SMC.

[admin]

We use a 12 volt air switch with 1/8 MPT. We buy they in large quanties and are looking for a good OEM source, preferebly an American made switch but we will consider others.

[admin]

I need help!I need to replace a plastic cup for the lubricator for my endload tester. Information as follows:Number: 508-02,Model:MI, Serial: 819.If you have any information regarding this please e-mail me quickly!Thank you!

[admin]

Hello Marlene,SCFM is a measurement of gas flow under a certain set of circumstances. Cv is a coefficient that can be used in a calculation to determine flow under a certain set of conditions. Cv is really more about a device’s “characteristics”

[admin]

I'm looking for a source of electrically-operated ROTARY valves for low-pressure (0.3psi) and high-flow (6 scfm) pneumatic applications. We’d like 6 or more ports.———–I now try to determine the required Cv…since this is my first time, I

[admin]

I AM LOOKING FOR A SUPPLIER OF SMALL 'AIR PUCK' STYLE ACTUATORS USED AS LIFT DEVICES IN ACCUMULATION CONVEYORS. THESE ARE NOT THE LARGER AND MORE EXPENSIVE UNITS MADE BY FIRESTONE, GOODYEAR, OR ENDYNE, BUT ARE SMALL 2 1/4 DIA. BY 3/4" THICK. TH"

[admin]

Take a look at the FESTO EV/AV series diaphragm design clamping modules.Regards.

[admin]

Would anyone out there know where to source heat sealable fittings for inflatible products?These are usually plastic male barbed connectors with a flange that can be bonded to vinyl or heat-sealable nylon (although the fitting could have a hinge

[admin]

Sourcing a single-use" device that will readily engage with and seal very thin wall(.008 ich) aluminum or stainless steel

[Author]

Posts