[admin]

We are known manufacturers and providers of solution to all problems related with compressed air or gas. If you can send us a detailed report of the exact problem we can provide with a permanent solution

[admin]

Clair,Most filters are design with a flow range in mind. A typical general purpose filter has a louver which spins the air around the bowl using centrifugal force to pull” large particulate and water out of the air. If you do not have enough fl”

[admin]

Clair, as the air exits the 1/8 tubing into the 1 1/2″ filter

[admin]

There is a company called Enerpac that will have what you need.www.enerpac.comRegards.

[admin]

YES : 1 Nm3/min is equal to 35.28 scfmAlso 1 Nl/min = 0.001 m3/min

[admin]

Some our customer ask for air compressor with capacity Nm3/min, pls tell me what is the difference between Nm3/min and m3/min? Thanks

[admin]

Try http://www.norgren.com

[admin]

http://www.rosscontrols.com/symbols2.htm

[admin]

I use Festo FluidDraw V4.It’s great!Only buy it from Festo USA as they charge for the CD. I almost bought a copy in Canada however, they wanted 8 CDN for the same thing. It exports .dxfs well and it’s generic for use.

[admin]

You should try Automation StudioI am using this software since version 2 and i find it the best solution to make circuit.here is there web site http://www.automationstudio.com

[admin]

You will need to use a relieving regulator. Depending on the load variations and times, the regulator will exhaust excess pressure when the load is increased. When the load is decreased the pressure will fill to compensate. If you use a non-rel

[admin]

Hi Jeromy,Thanks for the reply. From your advice I came up with the following:http://members.rogers.com/afeudale34/airsus.jpgA relieving electronic regulator sets the pressure, then to apply it to the cylinders, you toggle the solenoid valve. Th

[admin]

The 5/3 valve is going to dump from the front while adding to the rear. If the pressure is higher in the cylinders then at the regulator when you energize this valve, the front will dump while the rear will back flow to the regulator. I think yo

[admin]

Hi Eric,Sorry..I forgot to mention port 3 and 5 (the two exhaust ports) on the 5/3 valve will have threaded air blocks”

[admin]

Need the same size to be on a emergency airsupply unit.retained your info and will send you what I find.4/9/03Good LuckMartin Kinney

[Author]

Posts