[admin]

Need sub-base mounted spool valve.Flow 7 Nls or 14CFM FAD.Must be as small as poss and fast say 3 milliseconds.req 2way 2pos and 5/2Must be good price and unbranded or rebranded.

[admin]

Hi!My client based in central EuropeLooking for pneumatic fittings suitable for 10 bar (147 psi) operation.Possibly 1/4 NPT threads and push-in/on connections tp 6mm oder 1/4 odMust be able to see spike pressure of 40 bar now and then.Est order

[admin]

My application is for a battery operated diaphragm vacuum pump, free flow of 5.0 liters per minute, vacuum 0-10 Hg

[admin]

I would like to regulate the pressure in a unidirectional pneumatic cylinder using a solenoid operated pressure regulator. The cylinder will have a varying load on it (it is used as an air suspension).My question is:(1) If I use one of these re

[admin]

I am a student and I am trying to find information on the web on how to construct schematics

[admin]

You will need to use a relieving regulator. Depending on the load variations and times, the regulator will exhaust excess pressure when the load is increased. When the load is decreased the pressure will fill to compensate. If you use a non-rel

[admin]

Hi Jeromy,Thanks for the reply. From your advice I came up with the following:http://members.rogers.com/afeudale34/airsus.jpgA relieving electronic regulator sets the pressure, then to apply it to the cylinders, you toggle the solenoid valve. Th

[admin]

I noticed that compressor manufacturers state the flow capacity of their compressors in Nm3/min, scfm, Nl/min, l/min (ANR), etc.I beleived that these flow rate units are based in their respective standard reference conditions.So how can we conve

[admin]

Hi Eric,Sorry..I forgot to mention port 3 and 5 (the two exhaust ports) on the 5/3 valve will have threaded air blocks"

[admin]

The 5/3 valve is going to dump from the front while adding to the rear. If the pressure is higher in the cylinders then at the regulator when you energize this valve, the front will dump while the rear will back flow to the regulator. I think yo

[admin]

Hello Rene!Hoerbiger produces G1/4 and G1/8 units in plastics. If you need further help please contact me.

[admin]

Looking for an off the shelf manual hydraulic pump with an integrated flow control to operate two way miniature hydraulic cylinders.Thank you in advance.John

[admin]

There is a company called Enerpac that will have what you need.www.enerpac.comRegards.

[admin]

ODE is distributed by Granzow in the US.www.granzow.comRegards.

[admin]

I have an unusual application where a customer is using 33cfm compressor and strangely enough piping 1/8 pipe output into a 11/2" filter coelesting set

[Author]

Posts