Chosing the rigth walve/Cylinders/parts

ANVER

Home Forums Chosing the rigth walve/Cylinders/parts

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #19940
    admin
    Keymaster

    Hello. I am new to pneumatics.Sorry if this sounds stupid.
    I am planning to build a softdougt pneumatic cutter for my father bakery. It shall have 2 cylinders one vertical ( A ) pressing down and one horizontal ( B ) pushing the cutting blades. All this operation must be done in a 3 seconds time. The operation mode should be like this:
    Once comes in place the A Cyld press down and holds, B cyld cuts the dought and holds, A cyld retracts up, B cyld retracts back.
    What parts shoud I get or looking into make this possible?
    Thank you for your help.
    Regards

    #20962
    admin
    Keymaster

    I would recommend contacting a Manufacturer or Distributor to visit you and recommend a solution.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.