Reply To: air over hydraulic

ANVER

Home | Pneumatics Online Forums air over hydraulic Reply To: air over hydraulic

#20967
admin
Participant

This press would operate at 10,000 PSI to meet the 100 Ton requirement. This is a common pressure for hydraulic circuits powered by an ENERPAC or OWATONA high pressure setup. Both oof these companies make Shop Presses. As for stroke it depends on the type of Air-Oil pump. Both of the aforementioned companies make reciprocaing intensifiers that would allow for a continuous pressure for the full stroke. However, it will not be a fast stroke, in fact it willl probably be very slooooow.