seltecuae
Forum Replies Created
- AuthorPosts
adminParticipantBooster,intensifier, Multi-Power cylinder…. There are many choices. I think the real issue is what pressure do you ultimately need? 100? 200? 800? You need to figure that out first. This will tell you if either is aplicable. Then you need t
adminParticipantMidwest Pressure Systems sells turnkey air pressure booster packages that should fit you application
adminParticipantYou can increase the pressure by pushing a smaller cylinder with your larger cylinder. If you have 60 psi & 4 cylinder
adminParticipantYes you can do this using an intensifier. The approximate ratio is 54:1. However, you want to use a higher ratio.This will be much more expensive than a hydraulic pump. It will also be very slow using your onboard compressor.
adminParticipantHello Matt.I graduated from Cal State, SanBernardino in 89. One thing to be aware of is that an air over oil system is not used to generate high hydraulic pressure with a pneumatic signal.All air over oil is is utilizing oil in a cylinder instead
December 7, 2020 at 11:03 am in reply to: what applications would require valve with high speed and dynamic range? #21559adminParticipantWhat do you mean dynamic range?” High speed applications… There are a few that come to mind:Rice sorting machinery. The rice is dropped down the end of a conveyor. As the rice falls
adminParticipantI have a link to low cost check valves and relief valves. Be sure your supplier has low cracking psi, like 0.5psi or it may not be reliable in your application. We can make special runs of combined function parts with sufficient quantities. 1-88
adminParticipantBe sure your supplier has low cracking psi, like 0.5psi or it may not be reliable in your application. I have a link to low cost check valves and relief valves. We can make special runs of combined function parts with sufficient quantities. 1-888-
adminParticipantI believe ARO-Ingersoll Rand makes a version of their Module Air 2000 which will accept pressures that high. The difference is the sight glass. The higher pressure units do not have sight glasses. You should also look into High pressure air reg
adminParticipantContact SMC at 800-762-7621 and ask about the ARX series high pressure regulator. It’s small and inexpensive.Regards.
adminParticipantCan supply these.How many do you want?
adminParticipantWhy not use a simple contact closure. On one side of an oil filled diaphragm you could have foil. You could also have foil on the bottom. If there is impact they will open and you have a signal. KISS.
adminParticipantsorry only got this message now. Do you know any company that sells oil filled diaphrams or something similar to your suggestion or a company that could make these? much appreciated belatedly! Luan Cuffe!
adminParticipanthttp://www.rosscontrols.com/vresp.htmThe quick answer is that the reponse is determined by testing. How long to fill a specific volume with a given supply pressure? This will give an al most straight line curve (x + by = a) as the pressure build
adminParticipantdo u still nee this info?
- AuthorPosts
