AIR-OIL

ANVER

Home Forums AIR-OIL

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #20629
    admin
    Keymaster

    I am a mechanical engineering senior at Cal Poly and am not incredibly familiar with air-oil systems. I am thinking about fabricating a dumping bed system for my pickup. It would be possible to purchase a pto, hydraulic pump and ram for this a

    #21557
    admin
    Keymaster

    Yes you can do this using an intensifier. The approximate ratio is 54:1. However, you want to use a higher ratio.This will be much more expensive than a hydraulic pump. It will also be very slow using your onboard compressor.

    #21558
    admin
    Keymaster

    Hello Matt.I graduated from Cal State, SanBernardino in 89. One thing to be aware of is that an air over oil system is not used to generate high hydraulic pressure with a pneumatic signal.All air over oil is is utilizing oil in a cylinder instead

Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.