sstore sstore
Forum Replies Created
- AuthorPosts
- adminParticipant
Hi everybody,I am rather new to pneumatics so forgive me if this request seems out of this world. I am looking for a solenoid valve with the following specs… Max Pressure 250 psi Cv Factor >.5 Response (ms) Energise
adminParticipantIf you go the internet address below you will see that companies such as Compair are for sale, but not Norgren. There are so many industrial companies for sale by Invensys and Tyco, but so few buyers with the money to invest in the current climate
adminParticipantTry caontacting Parker Hannifen
adminParticipantAs a general rule that I've heard, 1 Cv = 25 SCFM so for 65 your looking at over 2 Cv. The max pressure should not be problem with most companies. 150 psi is typical but they usually have specials that go to 300 psi. Energizing in
adminParticipantThe valve will be used to actuate a cylinder on my senior thesis project. It's going on a robot with a lot of weight and space restrictions. Hence I'm looking for a really small, cheap (read: poor college student), high pressure, high flow, and
adminParticipantI HAVE AN EARLY 80'S INGERSOL-RAND 8CFM COMPRESSOR WITH SPRING STEEL WASHERS,USED AS POPPET VAVLES.I HAVE BEEN TOLD THESE ARE NO LONGER AVAILABLE,AS MINE ARE BROKEN ,BUT THE REST OF THE UNIT IS AS NEW,ANY IDEAS?,ANOTHER HEAD OR SOME VAVLES HIDIN
adminParticipantI do wish that some would take them over? I lostmy job with them after 14 years service !!!!!!I still keep in touch with them.over the past year they just seem to have lost the the plot!!!! customers seem to be the last thing on there mind.but I c
adminParticipantNot this again.The amount of times I hear this its a joke.Norgren will always be there.Forget about Parker.It will be a very long time before this happens.
adminParticipantI am looking for a small, inexpensive, D-frame, 6V DC, solenoid valve commonly found in take home, battery powered, blood pressure cuffs. I have a sample 14X15X21mm with a 3mm hose barb on one end with P/N TDS-V05B stamped on it. Who makes the
adminParticipantAll this buying and selling of companies has become a joke. They are playing monopoly with people's lives. Also the continual cost reductions are depressing. I wish all the cost cutters would go away so people can get back to growing sales instead
February 26, 2002 at 12:00 am in reply to: Calculating air flow thru partially open ball valve #20162adminParticipantChallenged with an in-house request to calculate air flow through partially open 1 and 3/4" dia standard ball valves. Which formula(s) would you use ?"
adminParticipantTake a look at our range at http://www.anver.com We have a thorough selection at very competitive prices.
adminParticipantI totally agree with Phil.The pneumatic industry is overcrowded some good some bad operators and these Big companies just destroy good small operators.
adminParticipantPeters is a GERMAN BASED MANUFACTURER FOR DIN43650 solenoid connectors, pressure sensors, proximity sensors (GMR and reed), illuminated gaskets for solenoid valve. We are now searching for a partner in the US and Canada. Any inquiries please sen
adminParticipantcan anyone advice please where one can purchase three phase bleeder type pressure switches either with a red push and pull button or a swivel knob, agents for telemecanique
- AuthorPosts