seltecuae
Forum Replies Created
- AuthorPosts
adminParticipantTry Humphrey Products, they only have a 1/4 valve for glue but you could start with them.#R332http://www.humphrey-products.com
adminParticipantHow about an over center toggle mechanism? They usually produce up to 10 times the power of a standard linear thrust.
adminParticipantDarell;I take it you are using Flow Controls in a Meter Out orientation. If so use regulated air at a pressure that is always available to the valve that operates the low weight end of the roll. Most plant air systems fluctuate throughout the day
adminParticipantDarrell;The circuit would work best if both cylinders had equal pressure on the raise side of the cylinders and variable pressure on the lowering sides. The heavy load side would be somewhat lower pressure on the lower the rolls side. The light lo
adminParticipantDo you have room to install a Rack & Gear assembly so that the roller can only raise or lower evenly?
adminParticipantPlease, contact me.We are a producer of pneumatic cylinders.T: 00421 51 74 80 464www.regada.sk
adminParticipantThis is an old pneumatic sequencer. The trimmer portion was to regulate the speed of the indexing. I don’t think it is available anymore.
adminParticipantAn impact wrench is working mechanically and is mainly used simply to close or open a screw. An impulse tool uses a medium (oil). Therefore the impulse tool is hammering smoother” and the tolerances are less (+-30% for impact
adminParticipantThe common sizes are 160 and 200. If you can modify your design to suit a standard size it would make things a lot simpler for you.
adminParticipanttry http://www.parker.com/actuatorselect rotary actuators” on the leftlook at the PRN or PV series”
adminParticipantPlease, contact me.I´m sure that we can replace FESTO by ours products : REGADA s.r.o.www.regada.skT: 00421 51 74 80 464
adminParticipantThough I am not sure about the products shown in photographs, I can tell you that Martonair is now part of IMI Norgren group. Please refer their website http://www.norgren.com
adminParticipantJim and Jamie,I understand that the From the Top corcenenfe was a great experience .as always. A suggestion regarding the Post Meeting Evaluation; add a section for comments on what the members would like to see as discussion topics or drill downs on a future agenda. Tom
adminParticipantThe least expensive is one from http://www.famictech.com/index_ang.htmat 0-600 It’s called Automation Studio and does what you are asking for Pneumatics, Hydraulics and Electrical. You can get a demo that runs 30 days to try before buying.The o
adminParticipantCould you please visit http://www.sms-tork.com.trweb pages for solenoid valve.tel:0090 216 3643405fax:0090 216 364 3757
- AuthorPosts
