homemade pneumatic forging hammer-more stroke

[admin]

I have built a pneumatic forging hammer and need some help to improve its power.I will state my basic question and then describe the system. I really appreciate any comments.Question:What can be done to increase the stroke of a cylinder given a

[admin]

Bob, I am by no means an expert on pneumatics, but I have been trying ,as you, to build a home made motor driven air forging hammer. One thing that I have found out is that the slave cyl. and the working cyl. must have the same bore, strok, and r

[admin]

I don’tknow how to increase the stroke on your air hammer, but I was wondering what would happen if you attached your shop compressor to the air inlet of your master cylinder? Would more air forced into your master cylinder result in more powerful

[Author]

Posts